Filter
Top Products
The Lower Paper Cassette
Using software commands
Some application programs can select either cassette directly from
the program. If your application program does not support two
paper sources, you may need to insert paper cassette selection
codes into your document using the following command (this
command can be used in LQ and FX emulation modes):
ESC EM n
If n = 1, the standard paper cassette is selected; if n = 2, the
lower paper cassette is selected.
If your printer does not feed paper from the lower paper cassette
after you have specified the source number in your application
program, the program may be sending codes that cancel lower
paper cassette selection. See the setup and installation instructions
for your application package.
Status messages
The error or status messages listed below may appear on the
display while you are operating the printer with the lower paper
cassette. See Chapter 7 for the steps to clear these messages.
PAPER SIZE ERROR
TRAY SET
PAPER OUT
PAPER OUT SET XXX
RESELECT TRAY
FEED JAM
PAPER JAM
Appendix A
A-21