Filter
Top Products
Memory Options
When to increase the printer memory
If you want to share the printer, you must increase the printer
memory with at least one memory chip set. Follow the instructions
in the next section to add a memory chip set to the controller
board.
If you are only using one channel, or if you are printing complex
graphics or dense text, the printer displays one of the status
messages listed below to alert you of insufficient memory. These
messages are described in detail in Chapter 7.
• INSUFF. MEMORY
• PAGE BUFFER FULL
•
ADD MEMORY FOR CH X
When one of these messages appears on the display, you can try to
reclaim any unused RAM by changing the settings for the
SelecType RX-BUFFER and FULL PRINT options. See Chapter 3
for information on changing SelecType options. If insufficient
memory is still a problem, you can install memory chip sets to
your controller board as described in the next section.
If one of the messages above appears on the display after you
increase the memory on the main controller board to the maximum
2 MB with memory chip sets, try to reclaim any unused RAM by
changing the settings of the RX-BUFFER and FULL PRINT options
in SelecType. If insufficient memory messages continue to appear,
you can install an optional memory expansion board as described
later in this appendix.
Appendix A
A-31