Filter
Top Products
136 Solving Problems
It sounds like the Stylus Photo RX600 is printing, but nothing prints.
■ The print head nozzles may need cleaning; see page 121 for instructions.
■ The Stylus Photo RX600 won’t operate properly if it’s tilted. Place it on a flat,
stable surface.
Printing or copying is too slow.
Make sure your system meets the requirements listed on page 151. If you’re
printing a high-resolution image, you need more than the minimum
requirements. You may also need to:
■ Clear space on your hard disk or run a defragmentation utility.
■ Close open programs that you’re not using.
■ Increase your system’s memory (RAM).
For the fastest printing:
■ Select Draft as the Quality Type (Windows) or set the Quality/Speed slider to
Speed (Macintosh) in your printer software.
■ If your document doesn’t include color, choose Black Ink Only (Windows) or
Black as the ink setting (Macintosh) in your printer software (see “Printing in
Windows” on page 36, “Printing on a Macintosh” on page 43), or press the
x
B&W button.
■ Tu r n Super MicroWeave
®
off (Macintosh only) and High Speed on in
your printer software.
■ If your Stylus Photo RX600 is connected to a USB hub, disconnect any
unused USB devices.
The margins are incorrect.
■ Make sure your paper settings are correct for your paper size. See “Printing in
Windows” on page 36 or “Printing on a Macintosh” on page 43.
■ Choose the correct margins for your paper size.
■ Make sure your paper is positioned on the right side of the sheet feeder with
the left edge guide lightly against its left side. Make sure the paper is beneath
the edge guide tabs. Don’t load paper above the arrow on the left edge guide.
SP RX600 Users Guide.book Page 136 Thursday, January 29, 2004 1:08 PM