Filter
Top Products
Printing from Film or Slides 95
Printing
1. Press the Film Print button to set the Stylus Photo RX600 to Film Print
mode.
2. Use the u and d buttons to choose
Custom Print, then press the OK button.
3. You see the film options on the right. Use the l and r buttons to choose your
film or slide type, then press the
OK button.
4. After the film or slides are scanned, choose the picture(s) you want to print
with the l and r buttons, then choose the number of copies for each photo
with the u and d buttons.
5. Press the
OK button.
6. Press the u and d buttons to highlight
Paper Type, then press the l and r
buttons to choose the type of paper that is loaded in the printer.
(If you’re not
sure about the paper type, see the table on page 87.)
Note:
It’s important to select the correct Paper Type setting for the paper you’re using, or
the print quality may not be what you expect.
7. Press the u and d buttons to highlight Paper Size, then use the l and r
buttons to select the size of paper you’ve loaded.
8. Use the u and d buttons to highlight
Resolution, then use
the l and r buttons to choose
Photo or Best Photo.
9. To restore color from faded images, use the u and d buttons to highlight
Restoration, then use the l and r buttons to choose On.
10. Use the u and d buttons to highlight
Layout, then use the l and r buttons
to select one of the following:
BorderFree: One photo per sheet, borderless; fits the photo lengthwise
on the paper
With Border: One photo per sheet, with borders around the edges
11. When you’re done adjusting print settings, press the x
Color button or
x
B&W button. Your print job begins printing.
Note:
To cancel a print job while printing, press the y Stop button.
SP RX600 Users Guide.book Page 95 Thursday, January 29, 2004 1:08 PM