Filter
Top Products
Krautkramer USN 52R/USN 52L Issue 05, 02/00 5-57
5.11 Setting the RS232 interface
In the center function group of the right table you will
find all functions for setting the serial interface RS 232.
If you connect a peripheral to the instrument via the
RS232 interface, you must always ensure that both
interfaces are configurated the same. This is the only to
guarantee error-free communication.
You can make the following settings for data transfer
(the default setting is indicated in bold type):
BAUD RATE Setting the transfer speed
• 300 Baud
• 600 Baud
• 1200 Baud
• 2400 Baud
• 4800 Baud
• 9600 Baud
LENGTH Setting the length of a byte
• 7 DATA BITS
• 8 DATA BITS
PARITY Parity check
• DISABLED
• EVEN
• ODD
Operation:
– Highlight the center function group in the center
function table with I.
– With M select the required setting for BAUD RATE,
LENGTH and PARITY.
H Note:
Also refer to the information about interfaces in Chapter
8.2
Setting the RS232 interface Operation
Krautkramer USN 52R/USN 52L Issue 05, 02/00 5-57
5.11 Setting the RS232 interface
In the center function group of the right table you will
find all functions for setting the serial interface RS 232.
If you connect a peripheral to the instrument via the
RS232 interface, you must always ensure that both
interfaces are configurated the same. This is the only to
guarantee error-free communication.
You can make the following settings for data transfer
(the default setting is indicated in bold type):
BAUD RATE Setting the transfer speed
• 300 Baud
• 600 Baud
• 1200 Baud
• 2400 Baud
• 4800 Baud
• 9600 Baud
LENGTH Setting the length of a byte
• 7 DATA BITS
• 8 DATA BITS
PARITY Parity check
• DISABLED
• EVEN
• ODD
Operation:
– Highlight the center function group in the center
function table with I.
– With M select the required setting for BAUD RATE,
LENGTH and PARITY.
H Note:
Also refer to the information about interfaces in Chapter
8.2
Setting the RS232 interface Operation