Filter
Top Products
5-54 Issue 05, 02/00 Krautkramer USN 52R/USN 52L
If USN 52R/USN 52L are set to the entry of freely for-
mulated texts, you will see the following display:
Entering texts
In the two lower lines you will see letters, numbers and
characters that you can use for the texts. To enter the
required text, start by selecting the entry position in
each case, and then select the character that should be
inserted at this position. The entry position and charac-
ter are each marked by a flashing cursor. You can enter
all required characters in any chosen order.
H Note:
You only need the TAB character for the entry in a data
header.
– Press the keys T or V to change the entry position.
– Press the keys N or O next to the corresponding
character string in order to select a character. The
flashing cursor changes the string automatically. The
highlighted character is immediately inserted at the
entry position.
– Finally, press the key X to store all entries.
If a data header was defined for the entry of additional
information, you will see e.g. this display:
The cursor flashes at the entry position.
Operation Data set names
5-54 Issue 05, 02/00 Krautkramer USN 52R/USN 52L
If USN 52R/USN 52L are set to the entry of freely for-
mulated texts, you will see the following display:
Entering texts
In the two lower lines you will see letters, numbers and
characters that you can use for the texts. To enter the
required text, start by selecting the entry position in
each case, and then select the character that should be
inserted at this position. The entry position and charac-
ter are each marked by a flashing cursor. You can enter
all required characters in any chosen order.
H Note:
You only need the TAB character for the entry in a data
header.
– Press the keys T or V to change the entry position.
– Press the keys N or O next to the corresponding
character string in order to select a character. The
flashing cursor changes the string automatically. The
highlighted character is immediately inserted at the
entry position.
– Finally, press the key X to store all entries.
If a data header was defined for the entry of additional
information, you will see e.g. this display:
The cursor flashes at the entry position.
Operation Data set names