Filter
Top Products
Four
User Installable Features
LifeBook C Series from Fujitsu
55
CAUTION
The memory upgrade module can be
severely damaged by electro-static
discharge (ESD). Be sure you are
properly grounded when handling
and installing the module.
10. Press the memory upgrade module down
into the compartment until it lodges under
the retaining clip. You will hear a click
when it is properly in place.
11. Lay the flap of plastic sheeting back
into place.
12. Flip the keyboard back over, and slide it
back into place with the tabs going into the
slots to the front of the notebook and hold-
ing the back of the keyboard approximately
on quarter inch up.
13. Let the back of the keyboard down, back
into place.
14. Carefully press the panel which you
removed back into place
15. Replace the screws and the screw covers.
The memory upgrade module is not something
you routinely remove from your notebook.
Once it is installed, you should leave it in
place unless you want to increase system
memory capacity.
6. Flip the keyboard away from you, and set it
down on the screen.
7. In the center of the plastic sheeting under the
keyboard is a small notch facing the right
side on your notebook. Ease your fingernail
under this notch, and lift the flap to your left,
exposing the memory upgrade slot.
Figure 4-4 Installing a Memory Upgrade Module and
closing the compartment
8. Align the memory upgrade module with the
chip side up. Align the connector edge of the
memory upgrade module with the connector
slot in the compartment. The connector will
be pointing toward your right. (Figure 4-4.)
9. Insert the memory upgrade module at a
45° angle. (Figure 4-4.) Press the connector
edge of the module firmly down and into
the connector.