Filter
Top Products
6
1.2 Placing Documents on the ADF
1. Align the edges of sheets in the document.
1) Confirm that all sheets have the same width.
2) Check the number of the sheets in the document stack.
The standard number of sheets that can be loaded on the scanner is as follows:
• A4-size paper or smaller that makes a document stack of 10 mm or less (100 sheets
at 80 g/m
2
or at 20 lb)
• Over A4-size paper that makes a document stack of 5 mm or less (50 sheets at
80 g/m
2
or at 20 lb)
2. Fan the sheets as follows:
1) Lightly hold the both ends of the stack with both hands, and bend it as shown in the figure
below.
2) Hold the stack firmly with both hands and bend them back so that the bent section rises up
in the middle of the stack as shown in the figure below.
3) Repeat steps 1) and 2) a couple of times.
4) Rotate the document 90 degrees, and fan the stack again.
3. Align the top of the sheets.
HINT
For details about paper sizes and paper materials for the ADF to work
properly, refer to Chapter 6 "DOCUMENT SPECIFICATIONS FOR ADF"
(page 121).