Filter
Top Products
2.9 Detecting Multifeeds
fi-5530C2 Image Scanner Operator’s Guide 61
SCANNING VARIOUS TYPES OF DOCUMENTS
2
2. Click the [Multifeed] button.
⇒ The following dialog box appears.
3. Configure settings in the [Specify Area for Multifeed Detection] dialog box.
1) Mark the [Enable] check box.
2) Select whether you want to specify an area to enable or disable multifeed detection.
• To specify an area for which the Multifeed Detection is performed:
⇒ Select the [Select area for applying Multifeed Detection] button.
• To specify an area for which the Multifeed Detection is NOT performed:
⇒ Select the [Select area for not applying Multifeed Detection] radio button.
3) Specify the [Start] position in the area.
Enter a distance from the top of the document as a starting position in millimeter.
(Select an even number from 0 mm to 510 mm)
4) Specify the [End] position in the area.
Enter a distance from the the top of the document. (Select an even number from 0 mm
to 510 mm)
HINT
• You can specify an area in the direction of the length of the document
for detecting multifeed errors.
• Unless the [Enable] checkbox is marked, the area of [Select area for
applying Multifeed Detection] or [Select area for not applying Multifeed
Detection] cannot be specified. In this case, normal multifeed detection
described above is performed. (Refer to "6.5 Specifying How to Detect
Multifeed" on page 129.)
ATTENTION
The number you enter as the [End] position must be larger than that of
the [Start] position.