Filter
Top Products
3.2 Cleaning the ADF
fi-5530C2 Image Scanner Operator’s Guide 83
DAILY CARE
3
• Feed and Eject rollers
1) Open the ADF when "P" or "0" is not indicated on the Function Number display.
If you open the ADF when "P" or "0" is indicated on the Function Number display,
the Feed/Eject rollers will not rotate even if you perform step 2) below.
2) Simultaneously hold down the [Send to] and [Scan] buttons on the operator panel.
The Feed/Eject rollers start rotating slowly.
3) Put a soft cloth moistened with cleaning fluid to the surface of the rotating Feed/
Eject rollers lightly so that the surface of the rollers is cleaned.
As a guideline, seven presses of the [Send to] and [Scan] buttons make the Feed/
Eject rollers to rotate one full turn.
• Plastic rollers
Clean the Plastic rollers lightly, preventing scratches on the roller surfaces. Take particular
care in cleaning these rollers as black debris on them adversely affects the pickup
performance. Be careful not to damage the sponges beside the rollers.
• Sheet guides
Wipe clean lightly.
• Glass
Wipe clean lightly.
• Ultra sonic sensor
Wipe clean lightly with a dry cloth.
In step 2), the Feed rollers turn at the same time while
rotating the Eject rollers.
When cleaning the Eject rollers, be careful not to touch
the Feed rollers and vice versa.
ATTENTION
If the glass gets dirty, vertical black streaks may appear in the scanned
images.
Function No.
display
Function
Send to
Scan
LED
Power button