Filter
Top Products
fi-5530C2 Image Scanner Operator’s Guide v
INTRODUCTION
Thank you for purchasing the fi-5530C2 Duplex Color Scanner.
This document describes how to handle the fi-5530C2 and basic operations. Before you start using the fi-
5530C2, be sure to read this manual thoroughly to ensure correct use.
This document describes the basic operation methods to perform scanning by using ScandAll PRO. The
version of ScandAll PRO bundled with this product is subject to change without notice, in which case the
screenshots captured in this document may differ from the actual displayed image.
For more information about ScandAll PRO, refer to the separate [ScandAll PRO V2.0 User's Guide].
■Regulatory Information
FCC declaration
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is located.
•Consult your dealer or an experienced radio/TV technician.
FCC warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTICE
The use of a shielded interface cable is required to comply with the Class
B limits of Part 15 of FCC rules.
The length of the AC cable must be 3 meters (10 feet) or less.