Filter
Top Products
Scanner Interface
Appendix A-58
If reserved value is specified, this scanner returns the following error information as follows:
• Status: B’00001’ (CHECK CONDITION)
• Sense key: X’5’ (ILLEGAL REQUEST)
(l) RIF (reverse image format) : Byte 1D, bit 7
This bit is used when the binary image data output is being reversed.
0: Output is not reversed
1: Output is reversed
If a 1 is specified for this scanner without the IPC-2 or IPC-2D option, this scanner returns
the following error information:
• Status: B’00001’ (CHECK CONDITION)
• Sense key: X’5’ (ILLEGAL REQUEST)
(m) Padding type: Byte 1D, bits 0 to 2
This scanner does not support Padding type. If a value other than B’000’ is specified, this
scanner returns following error information:
• Status: B’00001’ (CHECK CONDITION)
• Sense key: X’5’ (ILLEGAL REQUEST)
(n) Bit ordering: Bytes 1E to 1F
This scanner does not support bit ordering. If a value other than X’0000’ is specified, this
scanner returns the following error information:
• Status: B’00001’ (CHECK CONDITION)
• Sense key: X’5’ (ILLEGAL REQUEST)
(o) Compression type, argument: Bytes 20 to 21
Specifies the compression method that is applied before the read data is sent to the initiator
TYPE (Byte 20) Argument (Byte 21)
00 - Not compressed Reserved
01 - MH Reserved
02 - MR K parameter
03 - MMR Reserved