Filter
Top Products
4.3 Installation procedure
4-5
4.3.4 SCSI-ID setting
The default of SCSI-ID is 5. SCSI-ID is set by Setup mode of operator panel. The procedure to
set SCSI ID is;
(1) Turn the power ON by pressing “I” side of the power switch (see Figure 1.1). The scanner
displays “Scanner Ready” on the lower line of LCD.
Scanner Ready >
(2) Then press “Next” button. The scanner displays “Mode select 1”.
Mode select 1
Manual mode
change?
(3) Then press “Next” button. The scanner displays “Mode select 2” meaning that setup mode is
ready. Then press “enter” button.
Mode select 2
Setup mode Change?
(4) Then press “enter” button. The scanner displays as follows.
*01 Double Feed Check
= No/Yes --> 10/15/20mm
(5) Press “Previous” once, then the scanner displays “SCSI ID” on the upper line of the LCD.
*10 SCSI ID
= 0/1/2/3/4/5/6/7
(6) Select SCSI ID by pressing “ è “ or “ ç “ button, and press “Enter”. (SCSI ID is set.)
(7) Press “Exit” to return to “Scanner Ready” screen.