Filter
Top Products
5.1 Operator panel operation
5-5
Figure 5.2 Flow chart of the Setup mode
M01 Manual feed
=No/Yes
!01 Double Feed Check
=No/Yes → 10/15/20 mm
!02 IPC Pre-set
=No/Yes → 1/2/3/4/5
!03 Abrasion counter
=xxxxxx Reset No/Yes
!04 Pick start time
= 0.2 Sec
!05 Time-out limit
= 30 Sec
!06 ADF Front Offset
Change? No/Yes
!07 ADF Back Offset
Change? No/Yes
!08 FB Offset
Change? No/Yes
!09 IPC/Memory Status
IPC-2D / 32MB(TOTAL)
!10 SCSI ID
= 0 / 1 / 2 / 3 / 4 / 5 / 6 / 7
S42
S43
S44
S45
S46
S47
S48
S49
S4A
S4B
Previous
Previous
Previous
Previous
Previous
Previous
Previous
Previous
Previous
Previous
Enter
S41
Next, NO Enter
from S4B
M4
M3
Next
Previous
S31
Exit
Previous
Enter
Mode select 2
! Setup mode Change?
Mode select 1
M Manual feed Change?
To M1
(Figure 5.1)
Next,Enter,Exit
to M1
!02-1 IPC Host Setting
Ignore Yes/No
!03-1 Are you sure?
No/Yes
Enter at Yes
Enter
Enter at Yes
Enter
Enter at yes
!06-1 Return to default?
No/Yes
!06-2 Front Offset H
H= +0.0 mm (+:Left)
!06-3 Front Offset V
V= +0.0 mm (+:Up)
Enter
Enter
Enter
!07-1 Return to default?
No/Yes
!07-2 Back Offset H
H= +0.0 mm (+:Left)
!07-3 Back Offset V
V= +0.0 mm (+:Up)
Enter
Enter
Enter at Yes
!08-1 Return to default?
No/Yes
!08-2 FB Offset H
H= +0.0 mm (+:Left)
!08-3 FB Offset V
V= +0.0 mm (+:Up)
Enter
Enter
Enter
Enter at Yes
Next
Next,Enter
Next, NO Enter
Next,Enter
Next,Enter
Next,
No
Enter
Next,Enter
t
Next,Enter
t
Next, No Enter
Next, No Enter
Enter