Filter
Top Products
System Access 9
2.
Lower the panel and anchor its top edge to the chassis.
3.
Gently release the panel so that its side is flush against the chassis.
4.
Slide the panel forward until it is locked into place.
5.
Secure the panel with the screws you removed when you removed the
wrap-around panel.
Reinstalling the side panel
You must replace the bezel and the wrap-around panel before you replace
the side panel.
1.
Align the panel with the chassis ledges just a few inches towards the
back of the chassis. (See Figure 6.)
Figure 6: Reinstalling the Side Panel
To Replace the Side Panel
Important!
4081TL.book Page 9 Tuesday, December 22, 1998 1:27 PM