Filter
Top Products
EN
Service menus
195
Reports in extended service mode
The chart below shows reports that can be printed from extended
service mode and a brief explanation of each report:
Table 17. Extended service mode reports
Report Explanation
T.30 protocol trace
Prints a report of the G3 protocol transmissions and receptions. See the
section about fax trace reports later in this chapter for detailed information
about the report.
SRAM dump
Prints SRAM address values in an address range you select.
Scanner plots
Prints the calibration page.
Log debug report
Prints detailed fax and memory address information. Fax information includes
job number, start time used, fax ID, transmission type, pages, communication
mode, and status.
Task stacks
Prints address locations of various tasks.
Translations
Prints text strings used in the display, beginning with the number you select.
These text strings are printed in the language currently in use by the product.
You can compare the numbers in this report to the numbers in an English
report to translate non-English messages on the display.
Printer fonts
Prints all characters of fonts available in memory.
Firmware version
(under “memory/
softswitch”)
Shows firmware revision information on the control panel display.
White reference
summary (under
“scanner”)
Displays average, minimum, and maximum white reference values.