Filter
Top Products
EN
Control panel
43
Configuration
Err # (number 1-4)
An error was detected in the SRAM. Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Try plugging the power cord into a
different power source.
If the error persists, see Chapter 6,
“Troubleshooting.”
Config. Stuck Addr In Service Mode only, SRAM stuck
address test.
Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord. If the error persists, see
Chapter 6, “Troubleshooting.”
Config. Tied Addr. In Service Mode only, SRAM tied address
test.
Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord. If the error persists, see
Chapter 6, “Troubleshooting.”
Decoding Error #
(number 1-3)
There was an error in decoding with the
image processing chip.
Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Try plugging the power cord into a
different power source.
If the error persists, see Chapter 6,
“Troubleshooting.”
Documents Were
Lost START to
Continue
Power to the HP LaserJet 3100/3150
product was interrupted, and documents
in memory were lost.
Press S
TART
. The HP LaserJet 3100/
3150 product prints a report. Check the
Status column for the “Fax Document
was Lost” message. The associated
incoming and outgoing faxes should be
resent.
Encoding Error There was an error in encoding with the
image processing chip.
Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord. If the error persists, see
Chapter 6, “Troubleshooting.”
Errors Likely in
Pages
The fax transmission was completed, but
there are likely to be errors in the pages
specified.
Try resending the fax or asking the
sender to resend the fax to you.
Try faxing to another fax number.
Try connecting the product to a different
phone line.
Table 9. Control panel messages
Message Cause Solution