Filter
Top Products
44 Installation and operation
EN
Fax Document was
Lost
Faxes in memory were lost as a result of a
power failure.
If you set up faxes to be sent at a future
time or to be polled, or if the product
was set to receive faxes to memory,
print a fax log to identify the lost faxes.
The lost faxes should be resent.
Fax Memory Error
#(number 1-5)
An error was detected in DRAM. Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Try a different power source or surge
protector.
If the error persists, see Chapter 6,
“Troubleshooting.”
Group is Empty, Use
ONE-TOUCH/
SPEED DIAL
Appears when you are creating a group-
dial code.
Begin adding fax numbers to the group-
dial code. For more information, see
“Programming group-dial codes from
the control panel” in the user guide.
Input Limit Reached Too many fax numbers were dialed when
you tried to send to an ad-hoc group.
The maximum number of fax numbers
that can be added to an ad-hoc group is
100. Resend the fax to 100 or fewer
numbers.
Invalid Date or Time An invalid time or date was entered, such
as 25:99 PM or June 35
Re-enter the date and time. If the error
persists, see Chapter 6,
“Troubleshooting.”
Keypad Test Failed In Service Mode only, the keypad test
failed.
Check the cabling connections and run
the keypad test again.
If the error persists, see Chapter 6,
“Troubleshooting.”
Long Page?
START to Continue
The HP LaserJet 3100/3150 product
senses a document over 39 inches (991
mm), such as a banner, may be feeding
through the document feeder tray or that a
paper jam has occured.
If there is no jam, quickly press S
TART
to
continue scanning. If you do not press
S
TART
within a few seconds, the product
assumes that a page is jammed and
cancels the job.
If there is a jam, remove it and restart
the job.
If you are sending a fax or copying a
document longer than 39 inches (991
mm), you can also set the control panel
to use the “Send long pages” procedure.
Table 9. Control panel messages
Message Cause Solution