HP (Hewlett-Packard) 4100 All in One Printer User Manual


 
3
7
load originals and load paper
You can make copies from originals loaded on the automatic document feeder
(ADF). You can also print and copy onto a variety of paper types, weights,
sizes, and transparency films. It is important, however, that you choose the right
paper and make sure that it is loaded correctly and not damaged.
load originals
You can copy or scan any original by placing it in the automatic document
feeder.
1 Load your original in the automatic document feeder.
Note: Do not feed photos smaller than 3.5-by-5 inches through the
automatic document feeder.
2 Slide the right and left paper guides in until they stop at the edges of the
paper.
load paper
Following is the basic procedure for loading paper. There are specific
considerations for loading certain types of paper, transparency film, postcards,
and envelopes. After you review this procedure, see tips for loading other types
of paper in the paper tray on page 11, load 4 x 6 inch photo paper on
page 10, load envelopes on page 9, and load postcards on page 10.
For best results, adjust the paper settings each time you change paper types or
paper sizes. For more information, see set the paper type on page 12.
to load the paper tray
1 Lower the paper tray, and extend the paper-tray extender.
2 Slide the paper-width guide, on the left, to its outermost position.
automatic document
feeder (ADF)