Filter
Top Products
hp officejet 4100 series
chapter 3
8
3 Tap the stack on a flat surface to align the edges of the paper, and then
check the paper for the following:
– Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type, unless
you are working with photo paper.
4 Insert paper into the paper tray print-side down until it stops. To avoid
bending the paper, make sure you do not push the paper in too far, or
push too hard. If you are using letterhead, insert the top of the page first.
Be careful not to use too much or too little paper. Check that the stack of
paper contains several sheets but is no higher than the top of the paper-
width guide.
5 Slide the paper-width guide in until it stops at the edge of the paper. Make
sure that the paper stack lies flat in the paper tray and fits under the tab of
the paper-width guide.
6 Extend the output-tray.