Filter
Top Products
Table 6-16 Power Meter Readings Page Description (continued)
DescriptionFields and Buttons
Displays the maximum power reading from the server over the last 24-hour period. If
the server has not been running for 24 hours, the value is the maximum of all the
readings since the server was booted.
Maximum Power
Displays the minimum power reading from the server over the last 24-hour period. If
the server has not been running for 24 hours, the value is the minimum of all the
readings since the server was booted.
Minimum Power
Changes the displayed data from watts to BTu/hr. and from BTu/hr. to watts.Show values in BTu/hr
Refreshes the data graph.Refresh Data
Power Regulator
The Power Regulator page (Figure 6-19) enables you to view and modify the power efficiency
regulator mode of the system.
The Power Regulator feature is available on systems where support is provided by the operating
system, processors, processor dependant hardware (PDH), System Firmware (SFW), and iLO
firmware.
The following is required in order to use this feature:
• You must have the power control right to view and modify the power regulation modes.
• To access power and thermal history or the power regulator through IPM, requires both an
IPM license and an iLO (select or advanced ) license.
NOTE: Power regulation does not require the Advanced Pack license.
Figure 6-19 Power Regulator Page
NOTE: The BL c-Class tab is available only on HP Integrity server blades.
Table 6-17 lists the fields, buttons, and descriptions.
Web GUI 107