types are used simultaneously by the users, some users may see unexpected results. Only one
of the mirrored users at a time has write access to the console. Write access is retained until
another user requests console write access. To get console write access, enter Ctrl-Ecf.
To ensure proper operation of the remote serial console, verify the following conditions:
• Your emulator can run the supported terminal type.
• The iLO 2 MP terminal setting in the applet is a supported setting.
• The operating system environment settings and your client terminal type are set properly.
• All mirrored consoles are of the same terminal type for proper operation. Supported terminal
types are:
— VT100
— VT100+
— VT-UTF8
IMPORTANT: Do not mix hpterm and vt100 terminal types at the same time.
To connect to the system console (Figure 6-10), click Launch.
NOTE: If Launch is disabled, the user does not have console access right. See the User
Administration page under the Administration tab to add the access right.
Figure 6-10 Remote Serial Console Window
Using this feature you can do the following:
94 Using iLO 2 MP