Filter
Top Products
LC: LAN configuration usage
Command access level: MP configuration access
LC modifies the LAN configuration parameters.
IMPORTANT: If you are connected through a network and you make any changes to DHCP
status, IP address, subnet mask, or gateway IP address, the iLO 2 MP automatically resets once
you confirm the change.
If you are connected through a serial console and you make any changes to DHCP status, IP
address, subnet mask, or gateway IP address, the iLO 2 MP alerts you to manually reset the iLO
2 MP.
Configurable parameters include the following:
• iLO 2 MP IP address
• DHCP status (default is enabled)
— If the IP address, gateway IP address, or subnet mask was obtained through DHCP,
you cannot change the DHCP status without first disabling DHCP.
— If you change the DHCP status to enabled or disabled, the IP address, subnet mask,
and gateway address are set to their default values (127.0.0.1:0xffffff00), and the DNS
parameters are voided.
— When you change the DHCP status from enabled to disabled, the DNS parameters for
DHCP are set to disabled, and the Register with DDNS parameter is set to No.
— When you change the DHCP status from disabled to enabled, the DNS parameters for
DHCP are set to enabled, and the Register with DDNS parameter is set to Yes .
• iLO 2 MP host name
— The iLO 2 MP host name set in this command is displayed at the iLO 2 MP command
mode prompt. Its primary purpose is to identify the iLO 2 MP LAN interface in a DNS
database.
— If you change the iLO 2 MP host name and the IP address was obtained through DHCP
and DDNS is registered, a delete old name request for the old host name and an add name
request for the new host name are sent to the DDNS server.
— Typically you enter the DNS name for the LAN IP. You can program this field to any
useful name or phrase. For clarity, enter MPNAME-on-SYSTEM as the MP Host name,
so both names show up in the prompt. The limit is 19 characters, and no spaces are
allowed.
• Subnet mask
• Gateway IP address
• Local console serial port
• Link state
• SSH access port number
Command line usage and scripting:
LC [ -ip <ipaddr> ] [ -subnet <subnet> ] [ -gateway <ipaddr> ]
[ -host <text> ] [ -web <n> ] [ -link <auto|T<10baseT)> ]
[ -ssh <n> ] [ -dhcp <e|d> ] [ -nc ]
-?
See also: DNS, LS, SA
LDAP: LDAP directory settings
Command access level: MP configuration access
72 Using iLO 2 MP