Filter
Top Products
Table 6-17 Power Regulator Page Description
DescriptionFields and Buttons
Three are four modes in which the power regulator can operate. The power regulator
modes (Static Low, Static High and Dynamic) are independent of the operating system
and work for any operating system. The OS Control Mode requires Microsoft Windows
Server 2003 SP1 or later or Red Hat Linux 4 Update 2 or later.
Power Regulator Mode
Sets the processors to the appropriate power level based on the utilization of each CPU
core during the last 1/8 second. The CPU is set to the power saving processor power
state if the CPU is operating at a utilization level that can be completed at the slower
CPU frequency. The CPU is set to the maximum performance processor power state
if the CPU is operating at a utilization level that requires the fastest CPU frequency.
Enable Dynamic Power
Savings Mode
Sets the processor to the lowest supported processor state and forces the CPUs to stay
in that lowest state. This mode saves the maximum amount of resources, but it might
affect the system performance if processor utilization stays at or above 75% utilization.
Enable Static Low Power
Mode
Sets the processor to the highest supported processor state and forces the CPUs to stay
in that highest state. This mode ensures maximum performance, but it does not save
any resources. This mode can be used to create a baseline of power consumption data
without the power regulator.
Enable Static High
Performance Mode
Configures the server to enable the operating system to control the processor power
states. This is the necessary setting for OS power management. Moving from this state
to any of the three previous states requires a server reboot.
Enable OS Control Mode
Submits the selected function.Submit
Cancels the action.Cancel
Power regulation requires the server to have both a CPU and an operating system that is capable
of power regulation. Power regulation functions are available only when the OS is booted, and
the system has the required hardware, firmware, OS, and software.
The power regulation functionality is achieved through two different interfaces:
• Power Regulation through HP SIM (using the HP IPM plug in)
HP Insight Power Manager (HP IPM), a plug-in to HP Systems Insight Manager (HP SIM),
is an integrated power monitoring and management application that provides centralized
control of server power consumption and thermal output. It extends the unified infrastructure
management framework of HP SIM by providing new energy levers into the server.
Leveraging HP power regulator technology, HP IPM makes policy-based power and thermal
management possible. It expands the capacity of data centers by reducing the amount of
power and cooling required for supported Integrity servers and the server blades.
An Advanced Pack license is required to use the power regulation feature through the IPM.
Information on HP IPM is available on the HP website at: http://www.hp.com/go/ipm
• Power Regulation through the iLO 2 MP
The iLO 2 MP reads ACPI registers to gather information and display the current power
efficiency mode of the system. The available power regulator mode settings are sent to the
OS through an ACPI interface. If the OS is able to respond to the settings, it sets return codes
to note success or failure to reach these settings.
You do not need an Advanced Pack license to use the power regulation feature through iLO
2 MP.
Administration
The Administration tab enables you to access the following pages:
• Firmware Upgrade
• Licensing
108 Using iLO 2 MP