Filter
Top Products
Starting a System Console Session
To start a system console session, enter the following command:
</>hpiLO->start /system1/consoles1/textredirectsap1
Determining the Session Termination Character Sequence for the System Console
To determine the session termination character sequence for the system console, enter the
following command:
</> hpiLO-> show -d properties=SessionTerminateSequence
/system1/consoles1/testredirectsap1
status 0
status_tag=COMMAND COMPLETED
/system1/consoles1/testredirectsap1
Properties
SessionTerminateSequence=Esc (
Exiting the System Console Session and Returning to SM CLP
To exit the system console session and return to SM CLP, enter Esc + ( at the system text
console.
Entering the MP Main Menu Interface From SM CLP
To enter the MP Main Menu from SM CLP, enter the following command: </>hpiLO->start
/map1/textredirectsap1
Exiting the MP Main Menu Session and Returning to SM CLP
To exit the MP Main Menu interface and return to the SM CLP session, enter SMCLP
Firmware Revision Display and Upgrade
This section describes how to view firmware revisions in the system.
Each installed firmware in the system known to MP (MP FW, BMC FW, EFI FW, System FW,
and so on) is represented by a swid target.
• /map1/swinstallsvc1 represents iLO 2 MP’s ability to install firmware.
• /map1/swinventory1 represents a collection of all swids installed in the system.
SM CLP Firmware Targets
This section describes targets, target properties, and supported verbs necessary to implement
the firmware model in SM CLP.
Target: map1/swinstallsvc1
SoftwareInstallationService provides the ability to transfer images into a managed element from
a source location, local or remote (such as the ability to upgrade firmware).
Table 6-36 shows swinstallsvc1 target properties.
Table 6-36 swinstallsvc1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The value is set to firmware
installation service.
Provides a textual description of the object.Description
Verbs
134 Using iLO 2 MP