Filter
Top Products
TIP: Support for traditional fax transmission over any Internet protocol telephone
systems are often limited. If you experience problems faxing, try using a slower fax
speed or disabling the fax error-correction mode (ECM). However, if you turn off ECM,
you cannot send and receive color faxes. (For more information about changing the
fax speed, see
Set the fax speed. For more information about using ECM, see Send
a fax in Error Correction Mode.
If you have questions about Internet faxing, contact your Internet faxing services support
department or your local service provider for further assistance.
Use reports
You can set up the printer to print error reports and confirmation reports automatically for
each fax you send and receive. You can also manually print system reports as required;
these reports provide useful system information about the printer.
By default, the printer is set to print a report only if there is a problem sending or receiving
a fax. A confirmation message that indicates whether a fax was successfully sent appears
briefly on the control-panel display after each transaction.
NOTE: If the reports are not legible, you can check the estimated ink levels from the
control panel, the HP software (Windows), or HP Utility (Mac OS X). For more
information, see
Printer management tools.
NOTE: Ink level alerts and indicators provide estimates for planning purposes only.
When you receive a low-ink alert, consider having a replacement cartridge available
to avoid possible printing delays. You do not need to replace the ink cartridges until
print quality becomes unacceptable.
NOTE: Ensure that the printhead and ink cartridges are in good conditions and
installed properly. For more information, see
Work with ink cartridges.
This section contains the following topics:
•
Print fax confirmation reports
•
Print fax error reports
•
Print and view the fax log
•
Clear the fax log
•
Print the details of the last fax transaction
•
Print a Caller ID Report
•
View the Call History
Print fax confirmation reports
If you require printed confirmation that your faxes were successfully sent, follow these
instructions to enable fax confirmation before sending any faxes. Select either On (Fax
Send) or On (Send & Receive).
The default fax confirmation setting is Off. This means that a confirmation report is not
printed for each fax sent or received. A confirmation message indicating whether a fax
was successfully sent appears briefly on the control-panel display after each transaction.
Chapter 5
68 Fax