Q2431-90912 Chapter 6 Removing and replacing parts 139
Tray 1 pickup roller
Note If the optional envelope feeder accessory is installed, press the release button that is on the left
side and remove it. Then proceed to step 2.
1. Remove the front accessory cover (callout 1).
Figure 62. Tray 1 pickup roller (1 of 2)
2. Release the pickup roller by sliding apart the latches that are located on each side at the top
of the roller. Lift the roller out of the opening.
Figure 63. Tray 1 pickup roller (2 of 2)
Reinstall note When you install the pickup roller, place the two pivot pins in the lower mounting slots (callout 2)
and rotate the roller into the printer until it snaps into place.
11
222