Filter
Top Products
3-34 Troubleshooting and Diagnostics HP Omnibook 500
Power (APM) Menu Default
Intel SpeedStep Mode* Sets the speed used by a dual-speed processor at boot,
depending on the available power source. A separate Control
Panel power setting controls speed changes after boot.
Auto
Power Management Mode Disables time-outs, selects a pre-set combination of time-outs,
or allows customized time-outs.
Max. Power
Savings
Smart CPU Mode Enables automatic CPU power savings when running on
battery power. Absence of keyboard, mouse, and hard disk
activity could slow CPU response.
On
Suspend Time-out Sets the period of inactivity after which the computer goes
from full-power mode to Standby power mode.
4 minutes
Hibernate Time-out** Sets the period of inactivity after which the computer goes
from full-power mode or Standby mode to Hibernate mode.
(Skips Standby mode if the Suspend Time-out is disabled.)
4 hours
Hard Disk Time-out Sets the period of hard disk inactivity after which the internal
hard disk (and any hard disk in a plug-in module bay) stops
spinning.
2 minutes
Time-out on AC Sets whether power management time-outs occur while the
AC adapter is connected.
Disabled
Lid Switch Mode Sets the action that occurs if the computer’s lid is closed. Turn off LCD
Resume On Serial Ring Sets whether the system resumes if it receives a ring signal. Disabled
Resume On Time of Day Sets whether the system resumes at a defined time of day. Disabled
Resume Time Sets the 24-hour time when the system resumes if Resume
On Time of Day is enabled.
Auto Suspend on Undock* Sets whether the computer suspends to Standby mode after
undocking.
When Lid Closed
Auto Turn-On on Dock* Sets whether the computer turns on after docking. Enabled
* Windows 98 and 2000 use these settings.
** Windows 98 uses this additional setting.
Boot Menu Default
+Hard Disk
+Removable Device
CD-ROM/DVD Drive
Internal NIC
Shows the order of boot devices, with “+” indicating a device
category. Move the entries to change the order. If the
computer has more than one device in a category, you can
select the one scanned. Internal NIC (Network Interface Card)
appears in the list only if a built-in LAN is present—it provides
diskless boot from a network server.
1. Hard Disk
2. Removable
Device
3. CD-ROM/DVD
drive
4. Internal NIC
Exit Menu
Save Changes and Exit Saves Setup changes, then exits and reboots.
Discard Changes and Exit Discards any Setup changes made since last save, then exits
and reboots. Does not affect password, date, or time changes.
Get Default Values Restores default settings, and remains in Setup. Does not
affect password, date, or time changes.
Load Previous Values Discards any Setup changes made since last save, and
remains in Setup. Does not affect password, date, or time
changes.
Save Changes Saves Setup changes, and remains in Setup. Security
settings are saved when changed.