Filter
Top Products
reference guide
load originals and load paper
7
2 Tap the stack on a flat surface to align the edges of the paper, and then
check the paper for the following:
– Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type.
3 Insert paper into the input tray print side down until it stops. If you are using
letterhead, insert the top of the page first, face-down.
Check that the stack of paper contains several sheets but is no higher than
the top of the paper-length guide.
4 Slide the paper-width and paper-length guides in until they stop at the
edges of the paper. Make sure that the paper stack lies flat in the input tray
and fits under the tab of the paper-length guide.
5 Put the output tray back into position.
6 To prevent printed paper from falling off the tray, fully extend the output-tray
extender.