hp digital copier printer 410
chapter 8
50
paper use
This product is suited for the use of recycled paper according to DIN 19309.
plastics
Plastic parts over 25 grams are marked according to international standards that
enhance the ability to identify plastics for recycling purposes at the end of the
product’s life.
material safety data sheets
Material Safety Data Sheets (MSDS) can be obtained from the HP web site at:
http://www.hp.com/go/msds
Customers without Internet access should contact their local HP Customer Care
Center.
recycling program
HP offers an increasing number of product return and recycling programs in
many countries, as well as partnering with some of the largest electronic
recycling centers throughout the world. HP also conserves resources by
refurbishing and reselling some of its most popular products.
This hp product contains the following materials that may require special
handling at end-of-life:
• Mercury in the fluorescent lamp in the scanner (<2mg)
• Lead in solder
regulatory information
This section describes product requirements and contains statements from various
regulatory agencies.
FCC statement
The United States Federal Communications Commission (FCC) (in 47 CFR
15.105) has specified that the following notice be brought to the attention of
users of this product.
Declaration of Conformity: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Class B
limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,