Filter
Top Products
Chapter 4. Installation 113
3. When you see the following message, immediately press F5:
Setup is inspecting your computer’s hardware configuration...
If you plan to install the operating system on disks attached to a ServeRAID
controller, press F6 at this point so that you will be prompted to install the
ServeRAID driver as well.
4. When you are prompted to select the Computer Type, as shown in Figure 4-3,
select Other and press Enter.
Figure 4-3 Installing IBM custom HAL
5. Insert the xSeries 440 Windows 2000 HAL Support Disk (the one you
downloaded and created) into the diskette drive and press Enter.
6. Select eServer xSeries 440 (Windows 2000 HAL), as shown in Figure 4-4
on page 114 and press Enter. The necessary files will be copied from the
diskette.