Filter
Top Products
34 CMX158886 cpuModule BDM-610000049 Rev G
EIDE Connector (CN10)
The EIDE connector is a 44-pin, 2 mm connector that can connect to a variety of EIDE or IDE devices. The
connector provides all signals and power needed to use a 2.5-inch form factor (laptop) hard drive. Also, the first
40 pins of the connector provide all of the signals needed to interface to a 3.5-inch or 5-inch form factor hard
drive, CD-ROM drive, or other EIDE device. The larger form factors use a 40-pin, 0.1 inch spacing connector, so
an adapter cable or adapter board is needed to connect to CN10.
Table 15 EIDE Connector (CN10)
1
1. Signals marked with (#) are active low.
Pin Signal Pin Signal
1RESET# 2GND
3 DD7 4 DD8
5 DD6 6 DD9
7 DD5 8 DD10
9 DD4 10 DD11
11 DD3 12 DD12
13 DD2 14 DD13
15 DD1 16 DD14
17 DD0 18 DD15
19 GND 20 N/C
21 DMARQ 22 GND
23 DIOW#:STOP 24 GND
25 DIOR#:HDMARDY#:HSTROBE 26 GND
27 IORDY:DDMARDY#:DSTROB 28 GND
29 DMACK# 30 GND
31 INTRQ 32 N/C
33 DA1 34 PDIAG
35 DA0 36 DA2
37 CS0# 38 CS1#
39 DASP# 40 GND
41 +5 V (logic) 42 +5 V (motor)
43 GND 44 N/C