Filter
Top Products
Figure 32 shows an example of a DS3200 that is connected to one BladeCenter
unit.
Cabling the DS3200 power supplies
To connect the DS3200 power-supply cords, complete the following steps:
1. Connect a power cord to a power supply in the DS3200.
2. Attach the power cord to the strain relief guide that is on the underside of the
power-supply handle.
3. Repeat steps 1 and 2 for the second power supply.
4. Connect the other end of each power cord to a correctly grounded electrical
receptacle. For maximum protection against power loss, connect each of the
two power supplies to a different power source.
Figure 32. Example of a DS3200 that is connected to one BladeCenter unit
Chapter 3. Cabling the storage subsystem 43