7. Align the SAS host port adapter as shown in the following illustration. Secure
the front end of the adapter to the controller with the two screws that you
removed in step 5 on page 70, and then tighten the two blue captive fasteners.
8. Insert the controller into the chassis:
a. Slide the controller into the empty controller bay in the storage subsystem.
Make sure that the handle is pulled straight out as you slide the controller
into the bay.
b. Make sure that the guide pins on the side of the controller fit into the
notches on the DS3200 chassis. See Figure 42 on page 70.
c. After the guide pins fit into the notches and the controller fits snugly into
the bay, push the handle downward to fully latch it into place.
9. Reconnect the cables that you disconnected in step 3 on page 69.
10. Turn on the DS3200 (see “Turning on the storage subsystem” on page 46).
11. Wait up to 5 minutes for the DS3000 Storage Manager software to recognize
the controller.
12. Check the LEDs on the controller to make sure that the controller is fully
operational.
13. Use the DS3000 Storage Manager Subsystem Management window to check
the status of all components in the storage subsystem.
v If the controller is online and the DS3000 Storage Manager Subsystem
Management window indicates normal operation, go to step 16 on page 72.
v If the controller is online and the DS3000 Storage Manager Subsystem
Management window indicates a problem status, go to “Troubleshooting the
storage subsystem” on page 51.
v If the controller is offline, continue with step 14.
14. If the newly inserted controller is in an offline state, see the DS3000 Storage
Manager online help for instructions on bringing the controller online. If
necessary, open the DS3000 Storage Manager Subsystem Management
window and place the controller online; select the offline controller and click
Advanced → Recovery → Place controller online.
Screws
SAS host port adapter
Captive fasteners
Figure 44. Installing a SAS host port adapter
Chapter 5. Replacing components 71