Filter
Top Products
UEPTSTOK
Address of a 4-byte token which can be used to pass information
between successive enqueue requests within the same task (for
example, between successive invocations of the XNQEREQC exit).
UEPRECUR
Address of a halfword recursion counter. The counter is set to 0
when the exit is first invoked, and is incremented for each recursive
call.
UEPSCOPE
Address of the 4-byte ENQSCOPE name used.
Return codes
UERCNORM
Continue processing.
UERCPURG
Task purged during XPI call.
XPI calls
All can be used.
API and SPI commands
All can be used.
You can update the copies of EIBRCODE, EIBRESP, and EIBRESP2 that you are
given in the parameter list. If you update the values, CICS copies the new values
into the application program’s EIB after the completion of XNQEREQC or if you
specify a return code of UERCBYP in XNQEREQ.
You must set valid enqueue responses. You must set all three of EIBRCODE,
EIBRESP, and EIBRESP2 to a consistent set of values, such as would be set by
the enqueue domain to describe a valid completion. CICS does not check the
consistency of EIBRCODE, EIBRESP, and EIBRESP2. If EIBRCODE is set to a
non-zero value and EIBRESP is set to zero, CICS will override EIBRESP with a
non-zero value. To help you set values for EIBRCODE, EIBRESP, and EIBRESP2,
the values used by the enqueue domain are specified in DSECT DFHNQUED.
Note: Take care when issuing recursive commands not to cause a loop. For
example, it is your responsibility to avoid entering a loop when issuing an
enqueue request from the XNQEREQC exit. Use of the recursion counter
UEPRECUR is recommended.
The command-level parameter structure
The command-level parameter structure consists of a series of addresses. The first
address points to the EXEC interface descriptor (EID), which consists of a bit string
that describes the type of request and identifies each keyword specified with the
request. The remaining addresses point to pieces of data associated with the
request.
You can examine the EID to determine the type of request and the keywords
specified. You can examine the other parameters in the list to determine the values
of the keywords. You can also modify values of keywords specified on the request.
enqueue EXEC interface program exits
Chapter 1. Global user exit programs 59
|
|