Filter
Top Products
FRU information (service only) 79
To remove the speaker, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 40).
4. Remove the front bezel (see “Removing the bezel” on page 41).
5. Remove the support bracket (see “Removing the support bracket assembly” on
page 42).
6. Remove all adapter cards.
7. Unplug the speaker from the system board.
8. Gently push the two tabs of the adapter guide assembly inward until the
assembly is released; lift it up and out of the server.
9. Slide the speaker up and out of the server.
Bezel release latch
Before you begin:
• Read “Safety information” on page 105.
• Review the information in “Before you begin” on page 38.