Filter
Top Products
22 Hardware Maintenance Manual: xSeries 330
NDIS 4.0 (Windows NT) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation and
recommended action are included with each message.
Can’t unbind specified slot from AFT
group. Make sure that the slot you
specified is for the primary adapter in
an AFT group.
Explanation: The number entered in the unbind command was not the
primary adapter in an AFT group. Action: Reissue the unbind command and
specify the slot number for the primary adapter.
LAN adapter at slot nnnn (Port 0xaa)
failed to reset. Check the state of the
adapter.
Explanation: The adapter that you specified could not be initialized. Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and try loading the
AFT module again.
If the problem persists, contact your network supplier.
AFT is not supported on this version
of NetWare(TM).
Explanation: The NetWare on your server is not a version supported by AFT.
Action: Load and bind AFT only on supported versions of NetWare (currently
version 4.11 and above).
Failed to allocate resources tags. Explanation: An unknown error has occurred when trying to allocate needed
resources for the AFT module. Action: Check Server Configuration. If the
problem persists, contact your network supplier.
Please unload all LAN drivers before
unloading AFT.NLM.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver. Action: Unload the adapter driver before
unloading the AFT module.
Table 6. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller.
Error code (hex) Description
0x00 Explanation: The driver could not register the specified interrupt. Action: Using the
Configuration/Setup utility, make sure that a PCI interrupt is assigned to your Ethernet card, and
that Ethernet is enabled.
0x01 Explanation: One of the PCI cards did not get the required resources. Action: Using the
Configuration/Setup utility, make sure that a PCI interrupt is assigned to your Ethernet card, and
that Ethernet is enabled.
0x02 Explanation: Bad node address (multicast address). Action: Make sure the locally administered
address is valid, if one is specified. The address can not be a multicast address.
0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to the Ethernet connector. If the
problem persists, call for service.
0x0D Explanation: Could not allocate enough memory for transmit queues. Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue. Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the resource values that apply to the receive queue.
Table 5. NetWare driver messages for the Ethernet controller.