Intel 82540EP/EM Network Card User Manual


 
110 Software Developer’s Manual
EEPROM Interface
Table 5-8. Software Defined Pins Control (Word 10h, 20h)
Bit Name Description
15
SDPDIR[7]
SDPDIR[3] for the 82541xx
and 82547GI/EI
SDP7(3) Pin - Initial Direction.
Set this bit to 0b (default) to configure the initial hardware value of
the SDP7(3)_IODIR bit in the Extended Device Control Register
(CTRL_EXT) following power up.
Set this bit to 1b if not connected on a board or if used as an
output.
14
SDPDIR[6]
SDPDIR[2] for the 82541xx
and 82547GI/EI
SDP6(2) Pin - Initial Direction.
Set this bit to 0b (default) to configure the initial hardware value of
the SDP6(2)_IODIR bit in the Extended Device Control Register
(CTRL_EXT) following power up.
Set this bit to 1b if not connected on a board or if used as an
output.
13:10 Reserved Set these bits to 0b.
9 SDPDIR[1]
SDP1 Pin - Initial Direction.
Set this bit to 0b (default) to configure the initial hardware value of
the SDP1_IODIR bit in the Extended Device Control Register
(CTRL_EXT) following power up.
Set this bit to 1b if not connected on a board or if used as an
output.
8 SDPDIR[0]
SDP0 Pin - Initial Direction.
Set this bit to 0b (default) to configure the initial hardware value of
the SDP0_IODIR bit in the Extended Device Control Register
(CTRL_EXT) following power up.
Set this bit to 1b if not connected on a board or if used as an
output.
7
SDPVAL[7]
SDPVAL[3] for the 82541xx
and 82547GI/EI
SDP7(3) Pin - Initial Output Value.
Set this bit to 0b (default) to configure the initial power-on value
output on SDP7(3) (when configured as an output) by configuring
the initial hardware value of the SDP7(3)_DATA bit in the Extended
Device Control Register (CTRL_EXT) after power up.
Set this bit to 1b if used as an output.
6
SDPVAL[6]
SDPVAL[2] for the 82541xx
and 82547GI/EI
SDP6(2) Pin - Initial Output Value.
Set this bit to 0b (default) to configure the initial power-on value
output on SDP6(2) (when configured as an output) by configuring
the initial hardware value of the SDP6(2)_DATA bit in the Extended
Device Control Register (CTRL_EXT) after power up.
Set this bit to 1b if used as an output.
5:4 Reserved Set these bits to 0b.
3 EN_PHY_PWR_MGMT
Set this bit to 1b (default) to configure the initial hardware default
value of this bit in the Device Control Register (CTRL) following
power up.
Set this bit to 0b to not configure the initial hardware default value
of this bit in the Device Control Register (CTRL) following power
up.