Intel SBCEFCSW Switch User Manual


 
113
Total LIP received Number of loop initialization primitive frames received.
LIP F7F7 count A loop initialization primitive frame used to acquire an Arbitrated Loop Physical
Address (AL_PA).
LIP F8F7 count Currently not used.
LIP F7AIPs count This LIP is used to reinitialize the loop. An L_Port, identified by AL_PS, might
have noticed a performance degradation and is trying to restore the loop.
LIP F8AIPs Count This LIP denotes a loop failure detected by the L_Port identified by AL_PS.
LIP AIPdAIPs Count Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets, performed.
Class 2 In Frames Number of class 2 frames received by this port.
Class 2 Out Frames Number of class 2 frames transmitted by this port.
Class 2 Words In Number of class 2 words received by this port.
Class 2 Words Out Number of class 2 words transmitted by this port.
Class 3 In Frames Number of class 3 frames received by this port.
Class 3 Out Frames Number of class 3 frames transmitted by this port.
Class 3 Words In Number of class 3 words received by this port.
Class 3 Words Out Number of class 3 words transmitted by this port.
Decode Error Count Number of invalid transmission words detected during decoding. Decoding is
from the 10-bit characters and special K characters.
Loss Of Sync Count Number of synchronization losses (>100 ms) detected by this port. A loss of
synchronization is detected by receipt of an invalid transmission word.
Invalid CRC Count Number of invalid CRC frames detected.
Tx Wait Count Number of times the port entered a wait state because it was out of buffer-to-
buffer credits.
Class 3 Toss Count Number of class 2 and class 3 sequences that were discarded by this port. A
sequence can be discarded because of detection of a missing frame (based on
SEQ_CNT), detection of an E_D_TOV timeout, receiving a reject frame,
receiving frames for a stopped sequence, or other causes.
FReject Count Number of frames, from devices, that have been rejected. Frames can be
rejected for many reasons.
FBusy Count Number of class 2 and class 3 fabric busy (F_BSY) frames generated by this port
in response to incoming frames. This usually indicates a busy condition on the
fabric or N_Port that is preventing delivery of this frame.
Link Failures Number of optical link failures detected by this port. A link failure is a loss of
synchronization for a period of time greater than the value of R_T_TOV or by loss
of signal while not in the offline state. A loss of signal causes the switch module
to attempt to reestablish the link. If the link is not reestablished by the time
specified by R_T_TOV, a link failure is counted. A link reset is performed after a
link failure.
Primitive Sequence Errors Number of bad primitives received by the port.
Rx Link Resets Number of link reset primitives received from an attached device.
Table 28. Port Statistics Data window entries (continued)
Entry Description