Filter
Top Products
39
Set Setup command
Changes SNMP and blade server configuration settings. The switch maintains one SNMP configuration and
one configuration.
Authority
Admin
Syntax
set setup
snmp
system
Keywords
snmp
Prompts you, line-by-line, to change SNMP configuration settings. Table 11 describes the SNMP
fields. For each parameter, enter a new value or press the Enter key to accept the current value shown
in brackets.
system
Prompts you, line-by-line, to change blade server configuration settings. Table 12 on page 40
describes the system configuration fields. For each parameter, enter a new value or press the Enter
key to accept the current value shown in brackets.
Table 11. SNMP configuration settings
Entry Description
Contact Specifies the name of the person to be contacted to respond to trap events.
The default is Undefined.
Location Specifies the name of the switch location. The default is Undefined.
Trap [1-5] Address Specifies the IP address to which SNMP traps are sent.
Trap [1-5] Port Specifies the port for which SNMP traps are sent.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap events. The default is
Warning.
Trap [1-5] Enabled Specifies whether traps (event information) are enabled or disabled (default).
ReadCommunity Read Community Authentication. A write-only field; the value on the switch
and the SNMP management server must be the same.
WriteCommunity Write Community Authentication. A write-only field; the value on the switch
and the SNMP management server must be the same.
TrapCommunity Trap Community Authentication. A write-only field; the value on the switch and
the SNMP management server must be the same.
AuthFailureTrap Specifies the IP address where a notification is sent in the event of an
authentication failure.