Intel SBCEFCSW Switch User Manual


 
30 Intel Blade Server Switch Module SBCEFCSW Management and User’s Guide
switch
Initiates an editing session in which to change switch configuration settings. Each parameter is
displayed, one line at a time and prompts you for a value. For each parameter, type a new value or
press the Enter key to accept the current value shown in brackets. Type q to cancel the configuration.
SymbolicPortName Descriptive name
ALFairness Default is switch that has priority
ARB_FF Use ARB_FF instead of idles on loop FCAL option
InteropCredit Number of buffer-to-buffer credits per port. 0 means the default (12) is unchanged.
ExtCredit Extended credit port
FANEnable Fabric Address Notification. If enabled, notifies logged-in NL_Ports of the FL_Port
address, port name, and node name.
LCFEnable Link control frame preference, R_CTL = 0xC
MFSEnable Multi-frame sequence bundling
MFS_TOV MFS limit for camp on
MSEnable Management Server enable on this port
NoClose Do not close unless another device arbitrates
I/O Stream Guard Enables or disables the suppression of RSCN messages
VIEnable Not applicable
CheckAlps Close before sending frames to new target
Table 8. Set Config switch parameters
Parameter Description
AdminState Switch administrative state: online, offline, or diagnostics.
Broadcast Enable Enables (True) or disables (False) forwarding if broadcasting frames.
InbandEnabled Enables (True) or disables (False) the ability to manage the switch over an ISL.
DefaultDomainID Default domain ID setting.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the domain ID.
SymbolicName Descriptive name
R_T_TOV Receiver Transmitter Timeout Value. Specifies the number of milliseconds a port
is to wait to receive a response from another port. The default is 100.
R_A_TOV Resource Allocation Timeout Value. The number of milliseconds the switch waits
to allow two ports to allocate enough resources to establish a link. The default is
10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port is to wait for errors
to clear. The default is 2000 msec.
FS_TOV Fabric Stability Timeout Value. The default is 5000 msec.
Table 7. Set Config port parameters (continued)
Parameter Description