Filter
Top Products
Hardware Installations and Upgrades
Intel
®
Server Chassis SR1450 User Guide 65
Installing the SATA or SCSI Backplane
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable(s).
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4. Remove all hot-swap drive carriers. For instructions, see “Removing a SATA or SCSI Hot-
swap Hard Disk Drive.”
5. Set the backplane board in place so that the holes in the board fit through the pegs in the bottom
of the server chassis. See letter “A” in the figure below.
6. Slide the board to the right until it stops. Do not pull on any components on the board – grasp
only on the edges of the board.
7. Tighten the blue captive screw at the center of the backplane board. See letter “B” in the figure.
TP01607
A
B
B
Figure 48. Installing a SATA or SCSI Backplane into the Chassis