Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 20
5). Load Windows Driver
a) Load the Kodak 1200i System CD into CD-ROM drive (CD should launch
automatically). Select Software Installation, then Printer Setup.
b) A Windows driver will be loaded (just follow the default button selections). If
configuration is successful the printer will be automatically detected across the
new network (Note: the
picture at right is an
example only; printer name
and IP address should be
displayed correctly). If the
printer is not located
perform steps 1-5 again.
NOTE: Ensure Subnet
mask and Default Gateway
addresses are assigned
and are the same at both
the printer and the
workstation.
c) NOTE: If steps a. and b. above are unsuccessful then install a standard
TCP/IP printer port driver and configure or
assign an IP address to an
existing NJ1000i/Kodak 1200i printer driver (or TCP/IP port) to match the
printers IP address. If necessary add a Standard TCP/IP driver (load Generic
text only driver) if not already installed. Open up Printers (START – SETTINGS
– PRINTERS). Select an existing TCP/IP port and choose ‘Configure Port’ if
making a modification; please note the port name will stay the same.