Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 58
WASTE BOTTLE MISSING!
1. Insert or reinstall waste bottle. The actuator arm located at the
inside rear of the auto clean unit controls the sensor activation.
If the error persists then contact technical support.
2. Bottle present sensor may be defective; contact technical support for
assistance.
MAINBOARD ID ERROR!
This alarm provides the top-level MBID error status only. Additional information
about the specific error is available if the operator presses the “More Info” button.
The following is a list of all possible “More Info” specific error messages that
follow “Mainboard ID Error”:
MBID Error – Code < # > (# ranges from 0 to 7)
Where:
0 = “MBID Error - Record Mismatch!”
2 = “MBID Error - Pri CRC Failed!”
3 = “MBID Error - Sec CRC Failed!”
4 = “MBID Error - No Response!”
5 = “MBID Error - Write Protected!”
6 = “MBID Error - Copy Failed!”
7 = “MBID Error - MAC Mismatch!”
Translation: The ID-chip or its connection is faulty.
There is one more unique MBID error that can occur. This error will be displayed
only if there is an invalid OEM byte sent to the main-board chip at initialization
time. The OEM field is read from the ID chip. 1 = Kodak 1200i, 4 = POS, 5 =
Special, 6 = Xerox 8142/8160.
“MBID ERROR - INVALID OEM ID!”
In this instance, the manufacturer is required to change the OEM designation to
an approved OEM value before attempting another MBID Initialization process.
The Main PWA must be returned to the manufacturer as the software/hardware
components cannot be released outside of manufacturing.
NOTE: For printing to occur (be authorized) the main board OEM number must
also match the cartridge OEM value and the refill bottle OEM value. For example,
the KODAK printer version (UTILITY MENU – SERVICE MENU – ABOUT) must
have a main board value of 1 (i.e. MB: 90_01), the six cartridges (UTILITY
MENU – SERVICE MENU – CART INFO) must all be a value of 1, and the six
refill bottles must all be a value of 1. As well, the cartridges and bottles must also
have matching ink type (i.e. QiD) If a mismatch occurs printing will not be
allowed. Replace cartridge or ink bottle if a mismatch occurs.