Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 49
2. Ink System (Refill Bottle/Intermediate Reservoir) Error Messages:
BOTTLE ERROR - JOB PAUSED!
This bottle alarm provides the top-level error status only.
Additional information about the specific error is available if the
operator presses the “More Info” button. The following is a list of
all possible (color-generic) “More Info” specific error messages
that follow “Bottle Error”:
If the Bottle Error is related to an ID-chip data validation error,
one the following messages will be displayed:
[<color>] BOTTLE ERROR – INK RECORD MISMATCH!
Translation: The system was unable to update bottle ID-chip ink count.
[<color>] BOTTLE ERROR – INK LIMIT REACHED!
Translation: The bottle ink count is greater than maximum (700ml).
[<color>] BOTTLE ERROR – INVALID INK TYPE!
Translation: The bottle ink type does not match other installed bottle ink types.
[<color>] BOTTLE ERROR – INVALID OEM ID!
Translation: The bottle OEM ID does not match the main-board OEM ID.
[<color>] INK BOTTLE ERROR = CODE 7!
Translation: This message is an indication that the ID chip affixed to the bottle is
not working properly; incorrect programming, etc.
[<color>] BOTTLE ERROR: INVALID (CHIP) ID
Translation: This message is an indication the chip is the incorrect OEM version
[i.e. Encad (1) version vs. POS (4) version]. You can verify this condition by
going to the BOTTLE INFO screen (Utility Menu – Service Menu – Ink Status
Menu – Bottle Info) and, in normal operation you will typically observe:
An error condition will be displayed as:
K: ERROR*
***
NOTE: these error notifications typically occur during a running print job. In these
cases, the operator has 30 seconds to rectify the error before the job pauses and
an alternate version of this alarm appears. Some other rare messages include:
If the Bottle Error is related to an ID-chip communication failure, the error
message format changes to the following (BOTTLE ERROR - JOB
PAUSED!):