Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 51
screw may need to be loosened (T7 star-head screw) to readjust the housing
position slightly to enable better contact.
2. Verify proper chip placement on bottle – relocate chip as necessary. While in
the BOTTLE INFO screen ensure all ink type matches (i.e. QiD, QxD or Qi-
Pig). The printer will not print unless ink type is the same for all 6 bottles.
3. Replace the refill bottle with a new one.
<color>: WARNING - INK RESERVOIR LOW!
Intermediate reservoir (fed by the ink refill bottle) has reached the ‘low’ limit (<30
ml). Printing will only continue for only an additional 10 ml (typically for 10 – 25
minutes depending on print pass mode used).
1. This is a normal operational error and usually occurs when the
refill bottle runs out of ink and ink is now being depleted from the
intermediate reservoir (when ink level falls below 30 ml).
2. If current refill bottle contains ink then reseat the refill bottle to
ensure ink is being supplied to ink system. Remove and replace
ink refill bottle if necessary.
3. This error will normally occur, for all 6
colors, if the refill bottles have not been
installed into a new machine during the
initial installation and printer power is
applied. If ink bottles have been loaded and
the ink level within the intermediate
reservoir appears to be more than 60% full
(above the reservoirs 30 ml level) this error
should not be displayed. The intermediate
reservoir has a 52 ml capacity.
[<color>] JOB PAUSED – INK RESERVOIR EMPTY!
Message normally appears after 10 ml ink buffer has been used (refill bottle was
not replaced in time); occurs between 10 and 30 minutes following the INK
RESERVOIR LOW error message.
NOTE: This is typically a normal operational error and usually occurs when the
refill bottle level falls below 20 ml (error message WARNING - INK RESERVOIR
LOW! has already been displayed and an additional 10 ml of ink has been used.
1. It is possible to have a fault within the printer hardware caused by improper
electrical contact between main board and the reservoir data board, a defective
reservoir data board, or a defective connector or wiring harness. Verify
connectivity, select
Utility Menu – Service Menu – Diagnostics Menu – Accessory
Menu – Ink Reservoir Test.
If bottles are installed and intermediate reservoir
‘appear’ to be about 60% full, then all logic levels should be a one (1). If a zero
(0) is displayed and intermediate reservoir is full of ink, then either the sensor