Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 31
P
P
r
r
i
i
n
n
t
t
e
e
r
r
M
M
a
a
i
i
n
n
t
t
e
e
n
n
a
a
n
n
c
c
e
e
W
W
h
h
e
e
n
n
a
a
P
P
r
r
i
i
n
n
t
t
H
H
e
e
a
a
d
d
i
i
s
s
R
R
e
e
p
p
l
l
a
a
c
c
e
e
d
d
:
:
A. Check for air bubbles in the ink delivery line after replacing a print head:
- Perform an “Access Cartridge”
- Check for air segments of more than 5mm in length in the ink tubes; air bubbles are
acceptable but LARGE air segments are NOT acceptable.
Perfect Air bubbles acceptable NOT ACCEPTABLE
- If necessary, perform an ink load on ink lines which contain large air segments. Air
bubbles will be removed by a System Prime (must have new service station and f/w
1.5.0 or greater already installed).
- Select
Utility Menu - Prime Menu - Serv. Station Menu – System Prime. The System
Prime will take approximately 60 seconds to complete; all bubbles should be removed.
B. If air segments remain or ink line is completely empty:
- Install the Plug Bar and attach the ink line fitting to right side plate septum fitting;
remove the Print head and replace it with the Ink Load cartridge.
- Select
Utility Menu - Prime Menu - Serv. Station Menu - Pump On (hold button for 15
seconds).
- If this problem appears frequently after removing
and installing multiple print heads, then septum may need replacement (contact