Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 59
WAITING FOR CARTRIDGE ACCESS...
Reminder: A print job is ready but the system is waiting for the user to give up
control of the carriage. The user should press ‘Access Cartridge’ to return the
carriage and to enable printing to begin.
This error may easily occur following routine cleaning where cartridges were
accessed or if the operator decides to activate a ‘Cut’ following an ‘Access
Cartridge’ and the operator forgets to return carriage to home position.
WARNING: ADJUST REAR PAPER GUIDES
Friendly Reminder: Each time the paper is loaded this
message is presented to the user. The user should
inspect the paper path and press ‘Ok’ to clear this
warning. The front paper guides should be verified as
well.
NOTE: Always ensure the rear media edge guides
are spaced at least 1-2 mm away from the media
edges following a media load; the media should not
be in contact with the guide or media drag may occur and possibly cause left or
right side banding. Refer to Technical Bulletin 1 for complete media load
instructions.
CARRIAGE FPGA ERROR
Error: Normally this message indicates the carriage trailing cable or board is
unplugged. There is no method of clearing this error the printer must be power
cycled.
PEN ERROR!
This error message is provided to clarify a retained “Pen Error – Job Paused!”
error status after a job is “Reset” by the user and is no longer paused. Refer to
pages 1-8 above.
BOTTLE ERROR!
This error message is provided to clarify a retained “Bottle Error – Job Paused!”
error status after a job is “Reset” by the user and is no longer paused. Refer to
pages 9-12 above.