Filter
Top Products
KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide 3
Power Requirements
Either 115 or 230 volt, 50/60Hz source power is required for the printer. All major power
cord standards are supplied with each printer. The voltage selector switch is positioned
to the 230 volt position during shipping; ensure selector switch is set to either 115 or 230
for the appropriate region. The printer typically uses 1100 watts of power during normal
operation (when dryer is engaged) –a dedicated 20 amp circuit is ideal.
NOTE: The printer must be properly grounded in accordance with regional and general
equipment/electrical grounding guidelines or improper print operation may result and
personnel hazards may result if inadequate grounding is provided. Verify a ground line
(G) is present at power receptacle or power strip prior to installing the printer, refer to
receptacle examples below.
Connectivity Requirements
The printer can be connected directly to a computer via an Ethernet crossover cable or
via a regular Ethernet cable (RJ-45) connected to a 100BaseT HUB/Switch/Router
placed on the network. For DHCP (Dynamic Host Control Protocol) networks a static IP
address (dedicated address for printer) must be made available; consult a network
administrator to verify system setup.
China
UK/Singapore/
Hong Kong
US/Canada