Filter
Top Products
7-7
7.2. Reassembly Instructions
7.2.1. Attention when CF-18 series is repaired
• Please execute writing BIOS ID when you exchange the Main Board.
• Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.
7.2.2. Setting up the LCD UNIT
1. Set the LCD UNIT to the LCD FRONT CABINET/TS
PANEL.
2. Fix the LCD Back Damper using the 2 Screws. <Z>
3. Set the TS PS2 PCB on the LCD Back Damper, and con-
nect the 2 Cables to the Connectors (CN900 and CN901).
4. Set the INVERTER PCB to the LCD Back Damper, and
connect the 2 Cables to the Connectors (CN1 and CN2).
Screws <Z> :DXHM0042ZA
! Assembly of LCD Back Damper (Applicable Model : Touch Screen Model)
Inverter Case
Connector (CN2)
Connector (CN1)
Inverter PCB
TS PS2 PCB
Connector (CN901)
Connector (CN900)
LCD PCB SPACER ASSY
Asymmetric shape
The form of the left and
the right isn't symmetrical.
A
Remove the Release Paper
on the back side and attach it.
Lengthwise: Match to the LCD Frame.
Crosswise: Match to the middle line.
LCD PCB SPACER ASSY
Insert this between LCD PCB & LCD FARME.
Screw the Board
and the Spacer together.
Screw the Board
and the Spacer together.
(0~0.5mm)
Fit Holder Sheet&LCD Back Cushion Side
to the leftside end of LCD FRAME.
(0~0.5mm)
Hide the hook of the LCD FRAME.
0~0.5mm
0~0.5mm
0~0.5mm
0~3mm
Detail of "A"
B
LCD Back Cushion S
LCD Side Cushion A
Spacer Sheet
Spacer Sheet
LCD PCB Spacer
Screw<Z>
Holder Sheet
LCD Back Cushion Side
LCD Back Cushion Side
Screw<Z>
Screw<Z>
Screw<Z>
LCD Back Cushion S
LCD Back Cushion L
LCD Back Dumper
Holder Sheet
LCD Side Cushion C LCD Side Cushion D
LCD Side Cushion C
C
D
0~1mm
Pass the Cable under
the protrusion.
Detail of "B"
0~0.5mm
0~1mm
1~1.5mm
Detail of "C"
0~1mm
0~0.5mm
Pass the Cable under
the protrusion.
Detail of "D"
Pass the Cable
through the space.
Attach it to the side surface of the Frame.
(Match to the end of the Frame
within 0 to 0.5 mm at the far side.)
0±0.5mm
0±0.5mm
Set the LCD Back Dumper,
and then screw it.
Set the LCD Back Dumper,
and then screw it.
(0~0.5mm)
Hide the hook of the LCD FRAME.
(0~0.5mm)
Fit Holder Sheet&LCD Back Cushion Side
to the rightside end of LCD FRAME.
0±0.5mm
0±0.5mm
0±0.5mm
0±0.5mm